Fuseworks Decals may be used in electric or microwave kilns. The firing schedules shown below are only a point of reference for the decals in an electric kiln. You may need to adjust temps and timing, based on your kiln. (These instructions were supplied by a vendor for Fuseworks Decals.)
FUSING Schedule
1. 750F per hour to 800F – Hold 1 minute
2. As fast as possible to 1350F – Hold 15 minutes
3. As fast as possible to 1000F – to room temp.
SLUMPING Schedule
1. 300F per hour to 1000F - hold 15 min
2. 300F per hour to 1325F - hold 15 min
3. As fast as possible to 960F - hold 30 min
FUSING Schedule
1. 750F per hour to 800F – Hold 1 minute
2. As fast as possible to 1350F – Hold 15 minutes
3. As fast as possible to 1000F – to room temp.
SLUMPING Schedule
1. 300F per hour to 1000F - hold 15 min
2. 300F per hour to 1325F - hold 15 min
3. As fast as possible to 960F - hold 30 min
Thanks for sharing this! I bought some assuming there would be instructions for a regular kiln, but there weren't any!
ReplyDelete